RoadMachinerySparesScreed wear parts
How do you inspect a Dynapac paver screed wear strip?
A wear strip protects a specific contact area of the screed assembly. The replacement must match the position and profile, not merely the machine brand. Record the installed screed configuration before removing it.
Read the wear pattern
Check whether wear is uniform along the strip. Local gouging, bending or loose mounting points can indicate contact or support problems nearby. Compare matching sections on the opposite side and note any difference. If the strip failed soon after installation, inspect its seating surface before fitting another.
Keep the strip
Where it remains within the service limit and is securely mounted, document its condition for the next inspection.
Prepare a replacement
Where damage or wear exceeds the model-specific limit, record the exact section, hole pattern, profile and reference number.
Send a useful parts request
Include the paver and screed model, serial range, side and section, total length and photographs of both faces. State whether mounting hardware is needed. If the reference is unreadable, do not invent a number from a similar strip; use the screed drawing and measurements.
Confirm machine-specific limits and procedures with the appropriate service documentation.